pub trait TotalOrder {
// Required method
fn total_cmp(&self, other: &Self) -> Ordering;
}Expand description
Trait for floating point numbers that provide an implementation
of the totalOrder predicate as defined in the IEEE 754 (2008 revision)
floating point standard.
Required Methods§
Sourcefn total_cmp(&self, other: &Self) -> Ordering
fn total_cmp(&self, other: &Self) -> Ordering
Return the ordering between self and other.
Unlike the standard partial comparison between floating point numbers,
this comparison always produces an ordering in accordance to
the totalOrder predicate as defined in the IEEE 754 (2008 revision)
floating point standard. The values are ordered in the following sequence:
- negative quiet NaN
- negative signaling NaN
- negative infinity
- negative numbers
- negative subnormal numbers
- negative zero
- positive zero
- positive subnormal numbers
- positive numbers
- positive infinity
- positive signaling NaN
- positive quiet NaN.
The ordering established by this function does not always agree with the
[PartialOrd] and [PartialEq] implementations. For example,
they consider negative and positive zero equal, while total_cmp
doesn’t.
The interpretation of the signaling NaN bit follows the definition in the IEEE 754 standard, which may not match the interpretation by some of the older, non-conformant (e.g. MIPS) hardware implementations.
§Examples
use num_traits::float::TotalOrder;
use std::cmp::Ordering;
use std::{f32, f64};
fn check_eq<T: TotalOrder>(x: T, y: T) {
assert_eq!(x.total_cmp(&y), Ordering::Equal);
}
check_eq(f64::NAN, f64::NAN);
check_eq(f32::NAN, f32::NAN);
fn check_lt<T: TotalOrder>(x: T, y: T) {
assert_eq!(x.total_cmp(&y), Ordering::Less);
}
check_lt(-f64::NAN, f64::NAN);
check_lt(f64::INFINITY, f64::NAN);
check_lt(-0.0_f64, 0.0_f64);Dyn Compatibility§
This trait is not dyn compatible.
In older versions of Rust, dyn compatibility was called "object safety", so this trait is not object safe.